Bathroom Break Pass

If a student needs to be excused to take a potty break, they are going to need a pass! This kid craft project is just too adorable for teachers to pass up! Let your students go potty with class!

Materials:

DecoArt Products Required

• Americana Acrylics
  
  • DA199 - Primary Red
  • DAO10 - Cadmium Yellow (transparent)
• Americana Multi-Purpose Sealer
  • DS17 - Multi-Purpose Sealer
• Small unfinished wood tag, Lara's Crafts PT1001
• 1 1/4" round foam stencil brush
• 1/2" flat brush
• Ruler
• Scissors
• Foam plate
• Three 10" length scrapbooking school-themed ribbons
• Ultra fine point and fine point black permanent markers
• Flame lighter (optional)

Steps:

Note: Let dry after each step.

1. Use flat brush and Primary Red to paint tag.
    
2. Refer to photo and use foam stencil brush dipped in Cadmium Yellow to dot on center of tag.
    
3. Apply coat of Multi-Purpose Sealer to rectangle.
    
4. Use fine point marker to write letters for "POTTY PASS" over center of tag. Use ultra fine point marker to write teacher's name at hole end of tag.
    
5. Pull ends of three ribbons through hole of tag until center of ribbons are in hole. Tie knot at edge of tag.
    
6. Trim ribbon ends as desired and seal ends with flame lighter to prevent raveling.
    

Helpful Tip:

A hair dryer on low heat setting can be used to speed drying process of paint.