Metallic Disc Grid Wall Art

search

Metallic Disc Grid Wall Art

This is a great craft to decorate your wall while saving money. The metallic-finish spray paint gives it a perfect touch.

For more great wall decorating ideas, check out 19 Cool Wall Art and Decor Ideas.

For pattern, click here.

Materials:

  • STYROFOAM™ Brand Foam:
    • Discs, 6" x 1", nine
  • Holographic sticker paper, 8-1/2" x 11", nine sheets
  • Wooden strips, 1/4" x 1/8" x 24", five
  • Coordinating metallic-finish spray paint
  • Pencil
  • Ruler
  • Paper trimmer
  • Scissors
  • Fine-gauge craft wire
  • Craft pins
  • U-pins
  • Carpenter's level
  • Small saw or craft snips
  • Low-temp glue gun and glue sticks
  • Thick, white craft glue
  • Small nails, two

instructions:

  1. Cut two 1" x 11" strips from long edge of each piece of sticker paper; do not remove paper backing. For each pair of strips, peel back and remove 1" of paper backing at end of one strip and adhere it to one end of second strip, creating a 21"-long strip.
     
  2. Trace foam disc nine times onto back of sticker paper and cut out; again, do not remove paper backing.
     
  3. Spread thin, even coat of glue onto one side of first foam disc. Center one paper circle on disc; smooth paper with fingers. Repeat to cover all discs. Wipe away excess glue with damp cloth.
     
  4. In same way, cover disc edges with paper strips cut in Step 1; secure with craft pins and trim excess. Repeat to cover all disc edges. Wipe away excess glue with damp cloth. Let dry.
     
  5. Spray paint wooden strips; let dry. Use craft snips to cut three strips to 20" long; cut six 8" lengths from remaining strips.
     
  6. Refer to diagram and place discs facedown and 2" apart in a 3 x 3 grid pattern. Check for straightness and accuracy throughout rest of project.
     
  7. Use craft glue to glue three 20" wood strips vertically across center of each row of three discs; let dry.
     
  8. Glue 8" wood strips horizontally to connect the rows. For additional reinforcement, insert u-pins over wood strips and into foam. Let dry completely before handling wall sculpture.
     
  9. Cut two 3" wire lengths; twist ends of each length together around top back wood strips to form loops. Be sure loops are level; spot glue to secure. Hang art as shown.

 

®™ Trademark of The Dow Chemical Company ("Dow") or an affiliated company of Dow. For more project ideas, please see styrofoamstyle.com.

 

Your Recently Viewed Projects

Leave a Comment

Rate

Cancel Reply to Comment

Thanks for your comment. Don't forget to share!

Close

Report Inappropriate Comment

Are you sure you would like to report this comment? It will be flagged for our moderators to take action.

Thank you for taking the time to improve the content on our site.

Close Window