Brighton Style Jewelry Set

This Brighton Style Jewelry Set from Prima Bead makes a great gift for moms and sisters.  Made with lovely silver hearts, this beaded jewelry set is great to wear out on your Valentine's Day dinner.  Pick up some extra beads and make a matching necklace to go with your earrings and bracelet.  This is a simple jewelry pattern that's easy to follow for designers of all skill levels.

Materials:

• 145pc Starter Pack- Silver (#34719059)
• 5pc Silver Deco Heart (#34708289)
• 100in Small Silver Curb Chain (#34718092)
• 101pc 6mm Pearl/Crystal Mix Red (#34722035)
• 40' .3mm 7-Strand Bead Wire (#3202002)
   

Instructions:

Bracelet

1. Cut (10) 2 1/8” lengths of silver chain. Approx. 27 links each.
    
2. Take 5 lengths of the chain and connect each group of ends with a 2mm jump ring. Then repeat with the other 5 lengths of chain.
    
3. Now connect a 4mm jump ring to one side of each grouping of chains (this will be where you connect the toggle clasps).
   
   
    
4. Using the 4mm jump rings, you just attached to the chain groups, connect the two pieces of your toggle clasps.
    
5. Now onto the center of the bracelet. Start off by cutting a 4 inch strand of beading wire.
   
   
    
6. Crimp a small loop into one end of the wire leaving about 1 inch on one side and 3 inches on the other.
    
7. Thread the beads in order onto the wire.
    
8. Close the other end of the wire into a loop using a crimp bead. (If you leave enough extra wire to feed back through the heart it will be easier to pull the wire and form a tighter loop.
   
   
    
9. Finally, connect either end of your hearts to the 2mm jump rings on the ends of your pieces from steps 1-4.
   
   
    

Earrings

1. Cut (10) 1 ¼” lengths of chain. Approx. 19 links each.
    
2. Thread 5 lengths of chain onto a 2mm jump ring.
   
   
    
3. Now connect the 2mm jump ring to the loop on an eye pin.
    
4. Thread your beads in order onto the eye pin and create a loop on the end.
   
   
    
5. To make sure that your earrings hang correctly, you’ll need to connect a 2mm jump ring on the end of your eye pin before you connect earring wires.
   
   
    
6. Now repeat steps 1-5 to make the matching earring and you’re done!